|
| |
These instruments are especially designed for use
by electrical contractors in testing electrical installations for safe operating
and maintenance functions.
RCD Testers, Mains fault level testers ( PSC), Earth resistance, Insulation,
earth leakage and
general safety testers.
 |
Model :
T1700 Earth resistance ..
Tests and displays on a large digital display the
resistance between the earth stake and the actual earth resistance. The
resistance is very important to electrical safety. If the earth stake has
been placed in an incorrect area or has not made contact with the earth the
resistance can be higher than safety or the standards require. This can
cause the earth connection to be inefective or dangerous. This unit complies
with Australian standards and comes with 2 Earth stakes, long leads,
Reads down to 0.01 Ohms. 2 Ma test current will not trip RCD. measure
voltage up to 400v. Low Cost |
$399 Au
$295 US
Buy Now!
Spec Sheet |
 |
Model T1800:
Loop / PSC
A compact LOOP / PSC tester. Ever wondered what
rating a MCB should be in this installation ? 3KA, 4.5KA, 6KA, 10KA ? Dont
put the more expensive units in unless you have to and certainly dont under
rate the MCB and leave yourself and your employer open to legal action if
the worst happens. This unit will display the KA rating of any circuit,
without tripping the RCD by just plugging into a power point and pushing a
button. Digital display up to 20KA. Also displays AC voltage and Ohms down
to 0.01 max volts 240V AC |
$399 Au
$295 US
Buy Now!
Spec Sheet |
 |
Model T1900
This is a must have tester. Just plug it into any power point, push the
button and it will test the circuit for earth leakage protection by testing
the RCD for trip level, and will display the TRIP TIME in Milliseconds
(0.001 sec). This test is require for Australian standards. The self test
button on all RCDs only test the unit itself for trip level. This unit tests
that the unit is actually wired in and connected to the powerpoint and that
the trip time is quick enough to prevent serious injury. If the RCD trips at
the correct level but is slow inacting it is still dangerous for the user!
Measures down to 0.1 Ms, and trip currents up to 500 Ma. |
$350 Au
$265 US
Buy Now!
Spec Sheet |
 |
Model T3663: Insulation Tester
This insulation tester has a digital and an analog bar graph display.
The digital display is ideal for highly accurate readings and the analog is
good for a quick indication where the actual value is not needed. Reads
insulation up to 10 G ohms.
250 - 500 - 1000 V testing with digital display of the actual test voltage
on the screen. meets Australian Standards.
Tests Insulation, Voltage, and Ohms from 0.1 Ohm up to 10 Giga ohms. With
continuity buzzer for low ohms.
Complete with carry
case, leads, batteries and manual. Cat III 1000v Safety rated.
|
Model T3663
$350 Au
$265 Us
Buy Now!
Spec Sheet |
 |
Model MS5201: Insulation Tester
This insulation tester has a digital display.
The digital display is ideal for highly accurate readings and the values are
easily evaluated. Reads insulation up to 2000 Meg ohms.
250 - 500 - 1000 V testing . Meets Australian Standards.
Tests Insulation, Voltage AC/ DC Up to 1000V, and Ohms from 0.1 Ohm up to
200 ohms. Auto timer 1, 2, or 4 Min. Auto discharge after test. Power
warning light.
Complete with carry
case, leads, batteries and manual and tool box. Cat II 1000v and Cat III
600v Safety ratings. |
Model Ms5201
$250 Au
$195 Us
Buy Now!
|
 |
Model MS6800: Power Point Tester
Easy and quick to test power points , extension leads, and other
sockets. Just plug into a standard socket and the LEDs and an inbuilt buzzer
confirm up to 8 different wiring faults.
A standard 3 pin plug is fitted to the back of the unit. Testing takes just
a few seconds. Can be used by non technical people.
Max 240 V AC |
Model 6800
$29 Au
$20 Us
Buy Now!
|
 |
Model MS2007: Earth leakage Tester
This small clamp tester can detect very small currents from 0.1 mA up to
150 AAC. ( 3 ranges 0.2A, 2A , 150A)
Used for locating which equipment is generating RCD ( Earth leakage) Trips.
Just clamp the unit
over the earth line and measure the leakage of each circuit connected to
locate the area with earth leakage.
Also functions as a regular AC clamp meter with a range of up to 150 A AC.
large easy to read display.
Includes case, batteries and manual. |
Model MS2007B
$231 Au
$175 Us
Buy Now!
|
Key Benefits
- Professional test equipment
- 2 Year Warranty
- Meets Australian Standards
- Internationally highly reguarded manufacture TES Electronics
- All of the items on this page are complete
with carry cases and accessories.
|
